Hot Rod Garage Automotive

steve moynihan

14 Like
Cut Ready for

FireControl  [No Z]

This project is ready to be cut on a CrossFire CNC Machine.
Input your own cut settings on download to customize this file for your specific project.

Summary

1st file up load Its In a NC file should be able to open in Mach3 Hope it works for you.

License
Creative Commons - Attribution

You may distribute, remix, tweak, and build upon this work, even commercially, as long as you credit steve moynihan for the original creation.

Published

3 years ago

Downloads

649

Difficulty

Basic

Files
  • HotRod Garage.nc
  • steve moynihan (OP) - 3 years ago
    Anyone cut this out how did it turn out?

  • Steven Matney - 3 years ago
    made first cut fine then torch wouldnt come back down to cut. torch fired each cut.

    steve moynihan (OP) - 3 years ago
    sorry I have a crossfire XL table no Z axis maybe this is the problem My Torch dont move its set and stays in place.

  • John Godwin - 2 years ago
    it made the first cut but the second cut, which was the inside of the R it didn't cut but then it cut everything else really nice thanks John

  • Shaun - 2 months ago
    I'm getting a message that does not allow me to use my THC. It says the post processing is out of date for the current version of fire control. Could you provide me the file in DXF so I can run it through my own post processing setup?

Authentication required

You must log in to post a comment.

Log in