wolf tree Signs

KEITH

9 Like
Summary

Recommend not to go smaller than a 20 inch base. pictured sign is 16 gauge steel. make, recreate and distribute these file as you please.

License
Creative Commons - Attribution - Share Alike

You may remix, tweak, and build upon this work even for commercial purposes, as long as you credit KEITH and license your new creations under the identical terms.

Published

3 years ago

Downloads

366

Difficulty

Intermediate

Files
  • 1wolf tree.dxf
  • 1wolf tree.jpg
  • 1wolf tree.svg
  • 1wolf tree.jpg
  • Brandon Neal - 3 years ago
    hey keith thasnk you for the design! i was hoping you could give me some recommendations for setting my plasma cutter.. i have a RW45 and am using sheetcam.. THANKS AGAIN, im making this as a present for my mom

    KEITH (OP) - 3 years ago
    Brandon, on my rw45 I used 16 gage steel 35amps 120ipm pierce delay 0.7, but with these settings I had a lot of dross and alot of clean up time.

Authentication required

You must log in to post a comment.

Log in