Run Programs, jog with ease and continuous motion or defined steps, stored work coordinates.
Program Visualizer
Smooth moving, zoomable display shows you current torch location, cuts to make, rapid motion, and cuts already made.
Scale & Rotate
Scale or rotate your program directly in FireControl without having to re-post your program.
Dry Run Mode
Test run your program without Plasma firing and Z-axis moves.
Patterning
Cut multiple copies of your project on the fly.
Straight Cut
Trim material under machine control on the fly.
Touch Screen Friendly
Designed to work without a mouse with keyboard shortcuts.
Auto-connect and disconnect
FireControl automatically connects to your CrossFire Machine.
Run From Here
Pick up a missed cut from any line or cut loop in G-Code or selected from the visualizer.
Set Program Origin
Change the origin location of your program directly in FireControl.
Feed Rate Override
Speed up the cut speed of a program on the fly.
Pierce Delay Override
Increase the Pierce Delay on the fly.
Manual Nest Jog
Firecontrol calculates program extents and shifts coordinates to allows for quick manual nesting.
Additional Features
Automatic Torch Height DRO with Settings
Built in ATHC Control panel with:
Real-time Voltage, Nominal or Smart Voltage and tolerance.
Height Up/Down/OK signal display.
Real-time Torch Speed with on-the-fly torch speed cutoff to prevent torch diving.
Support
POST Processors for Fusion360, and SheetCAM available on the Langmuir Systems Downloads Page.
Community Driven Development Roadmap including support for new features, additional CAM software,
Linux compatibility. See the FireControl Category on the Langmuir Systems Forum.